Acufine as one shot: dilution? time?

Film Photography & Darkroom discussion

Moderator: Keith Tapscott.

Post Reply
Bob Michaels
Posts: 2
Joined: Mon Aug 22, 2011 2:10 pm

Acufine as one shot: dilution? time?

Post by Bob Michaels »

I like one shot developers. I bought Acufine since ACU-1 (one shot Acufine) could not be located. Using stock solution of Acufine as a one shot would get very expensive, very fast.

I am told by Jon Mided (Digital Truth) that Acufine and ACU-1 are different compositions and I cannot just dilute Acufine as if it were ACU-1 and use the ACU-1 suggested times. Jon suggested I ask here.

Does anyone have any experience using diluted Acufine as a one shot developer? If so, please share.

Ornello
Posts: 882
Joined: Thu Jan 19, 2006 9:49 am

Re: Acufine as one shot: dilution? time?

Post by Ornello »

I would suggest using it 1:1 and extending the recommended time by 30% as a starting point, but you should certainly run trials before doing 'good' rolls. Also try 1:2 for 50% more time (1 part stock to 2 parts water).

pirateoversixty
Posts: 221
Joined: Sun Jun 18, 2006 1:21 pm
Location: Peoria, Illinois

Re: Acufine as one shot: dilution? time?

Post by pirateoversixty »

Used to use Acufine quite a bit years ago as a one-shot developer. Seems I used it as 1+1 and 1+3 with similar results: a slight bump in ei, negs looked like d-76 product. Ornello's times sound about right. Worth a try but don't expect the silver bullet.
Jim

Bob Michaels
Posts: 2
Joined: Mon Aug 22, 2011 2:10 pm

Re: Acufine as one shot: dilution? time?

Post by Bob Michaels »

Thanks guys. I'll shoot a few rolls of unimportant things in the normal flat interior light that I need to push and give the dilutions / times a try.

I am curious to see what the downside of Acufine is. I know everything ends up being a compromise so am a bit skeptical of the claims of e.i. boost, ultra fine grain and maximum acutance.

Jim Appleyard
Posts: 80
Joined: Sun Mar 25, 2007 4:33 pm

Re: Acufine as one shot: dilution? time?

Post by Jim Appleyard »

A good place to start for times is right here at DT; just go to the Massive Dev Chart.

Acufine can be used at stock or 1+1. Grain will be increased, as will contrast, but it may allow you to get a photo when you couldn't otherwise. Most of my Acufine images look "pushed", especially going to 3200.

Tri-X is very good for pushing (let's not get into the "what pushing is" debate) and I've done EI 3200 with Acufine, although it tends towards "soot & whitwash".

Times:

TX a @ EI 1000 Acufine 1+1 for 10 min. 21C
1600 14
3200 21

TMZ can be shot at EI 6400 in Acufine 1+0 for 7.5 min. 21C

I prefer to shoot TX @1000and soup in Diafine. Diafine is so easy. lasts a long time and controls contrast by its two bath dev method and the image doesn't look pushed. The only drawback is that the EI is fixed. With Acufine, you can up your EI by increasing the time or by going from 1+1 to 1+0.

Post Reply